TREND H/JIG/A HINGE JIG TWO PART IN CASE

Trend Routing On-Site Jigs - Trend Hinge Jig A - Hinge Jig Two Part In Case - (Ref: H/JIG/A)

The two part Contractor Hinge Jig is a portable template set designed for recessing hinges in wooden doors & frames using a plunge router

• It is easy to use with minimal setting-up time, completing the job both accurately & quickly
• Used on-site & in joinery shops to increase productivity with excellent results
• Four apertures for fire door requirements
• No need for marking out in the conventional way
• Quick & simple to set-up as the hinge is used as the pattern
• Clean & accurate recesses are achieved every time. Suitable for timber based doors & square butt hinges
• Can be used on both inside and outside doors, rebated frames and on maximum 25mm thick fixed stops
• Use with a light duty plunge router with 1/4 inch collet
• Long reach router cutter required, 12mm diameter with 70mm overall length
• Angled position slots to prevent creep
• Unibase may be needed
• T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160

• 4 x Apertures
• 2 x Bradawls with spacer
• 1 x 16mm guide bush
• 1 x T-Handle hex key 4mm
• 1 x 4mm spacing gauge
• 1 x Carry case

• Length min: 2 5/8" (67 mm)
• Length max: 5" (127 mm)
• Width min: 3/8" (9.5 mm)
• Width max: 1 3/8" (35 mm)
• Width max. in 35mm rebate: 20 mm
• Width max. in 44mm rebate: 30 mm
• Door sizes possible
• Height min: 6' 5" (1955 mm)
• Height max: 2100 mm*
• Thickness min: 5/8" (16 mm)
• Weight 3.3 kg
• Jig overall length 1957 mm
• Plate thickness 2 mm
• Fixed stop max. thickness 25 mm**